MH90 X 21 inch Tube Center Valve Metal Stem 325/350 style center valve inner tube with metal stem. Instructions: http://www.vtwinmfg.com/Instructions/MS/Tire Valve Stem Chart.PDF

Micro Cateye Tail Lamp Black Micro cataye tail lamp features a black finish.

Micro Cateye Tail Lamp Chrome Micro cateye tail lamp features a chrome finish.

Mid Control Brake Kit Brake pedal mount plate is fastened to transmission side cover with longer black allen screws supplied (3) 3/8 inch-16 x 1-1/4 inch and (2) 5/16 inch-18 x 1-1/4 inch. *NOTE: Brake lines must be selcted from...

Mid Control Footpeg Mount Set Sold as a set of 2. Measurements: Thread: 1/2 inches -20 FITS Harley Davidson FLST 1986 Harley Davidson FLST 1987 Harley Davidson FLST 1988 Harley Davidson FLST 1989 Harley Davidson FLST 1990 Harley Davidson FLST...

Mid Control Shifter Kit Components are supplied in a bright zinc plated finish. Zinc plating readily accepts painted finish. Use suitable primer and finish coat. Footpeg not included. FITS Harley Davidson FLST 1986 Harley Davidson FLST 1987 Harley Davidson FLST...

Mid Control Shifter Shaft For mid shifter control. Shaft has splined end to fit shifter lever and extended lever to fit over outer primary. Tech Notes: Suggested to use with #22-1849 Mid Control Shifter Kit FITS Harley Davidson FLST 1989...

Mid Control Shifter Shaft Extension Kit Mid control shifter shaft extension kit includes extension washer and screw. FITS Harley Davidson FLST 1989 Harley Davidson FLST 1990 Harley Davidson FLST 1991 Harley Davidson FLST 1992 Harley Davidson FLST 1993 Harley Davidson...

Mid Shifter Lever Retainer Chrome Chrome retainer will secure inner primary shift lever when installing forward controls.

Mid Shifter Lever Retainer Chrome Chrome retainer will secure inner primary shift lever when installing forward controls.

Middle Finger Fender Ornament Ornament is for fender or surface. Mounts with two screws. *NOTE: Pewter type metal. Measurements: Mount Threads: 1/4 inches

Middle Finger License Plate Topper Middle finger license plate topper.

Middle Finger License Plate Topper with Stud Mount Chrome middle finger license plate topper with 1/4 x 20 inch stud mount.

Mikuni HSR 42/45mm Carburetor Rebuild Kit Mikuni HSR 42/45mm carburetor rebuild kit includes needle valve assembly.

Mini 12 Volt Battery For custom application on 1948-1964 FL Panheads. Battery has a right side vent position and and has a maximum charge rate of 0.6. Do not overfill battery fill to the line level as noted. When refilling...

Mini 48mm Speedometer with 2240:60 Ratio Mini 48mm speedometer has a ratio of 2240:60 and includes cable and mount clamp. Numbers read 0-140 mph.

Mini 48mm Speedometer with 2240:60 Ratio Pre 1980 models tap into orange wire exiting turn flasher. 1991-up models signal indicator light can not be used.

Mini 48mm Speedometer with 2:1 Ratio Speedometer does not have LED

Mini 48mm Speedometer with 2:1 Ratio The length of the cable from nut to end is 41-3/16 inch. For custom application on 1973-1994 FX models.

Mini 60mm Electronic Speedometer Includes extension harness for wiring to stock speedometer sensor. Measurements: Diameter: 2.644 inches Instructions: http://www.vtwinmfg.com/Instructions/39/39-0540.pdf

Mini 60mm Electronic Tachometer When replacing a coil triggered tachometer on 1978-up models the green negative wire goes to the negative side of the coil. The red wire goes to the ignition side of the key switch. The tachometer head...

Mini 60mm Speedometer Kit with 1:1 Ratio Can be installed without any adapters or modifications. Custom application on 1971-1983 models.

Mini 60mm Speedometer Kit with 2240:60 Ratio Kit can be installed without any adapters or modifications. For custom application on 1984-1996 FXST and 1986-1996 FLSt models.

Mini 60mm Speedometer Kit with 2:1 Ratio Includes gauge chrome bracket rubber handlebar clamp and proper cable which can be installed without any adapters or modifications.