Front Turn Signal 36 inch Extension Harness Kit
This extension harness will allow the installation of taller than stock bars and the relocation of turn signal assemblies. The only way to move the turn signals is to cut the turn signal wiring that is hard wired into the circuit board installed in the handlebar switch housing. This harness will allow you to cut the wiring heat shrink the cut wire to prevent a short solder on extension harness and simple connect the other end of the harness into the factory connector located under the fuel tank.
FITS
Harley Davidson FLST 2011
Harley Davidson FLST 2012
Harley Davidson FLST 2013
Harley Davidson FLST 2014
Harley Davidson FLST 2015
Harley Davidson FLST 2016
Harley Davidson FLST 2017
Harley Davidson FXD 2012
Harley Davidson FXD 2013
Harley Davidson FXD 2014
Harley Davidson FXD 2015
Harley Davidson FXD 2016
Harley Davidson FXD 2017
Harley Davidson FXST 2011
Harley Davidson FXST 2012
Harley Davidson FXST 2013
Harley Davidson FXST 2014
Harley Davidson FXST 2015
Harley Davidson FXST 2016
Harley Davidson FXST 2017
Orders over $145.95 qualify for free shipping.
Orders under $145.95pay a flat shipping rate of $10.95 Offer only applies to 48 contiguous states. Hazardous Materials ship UPS Ground only.
Orders that contain backorders, the order will be held until all parts are in. A customer representative will reach out to you if this is the case. At that time a decision can be made whether or not to split the order.
Alaska orders will be charged a flat $35 charge and will be shipped Post Office Priority Mail. We do not ship Oversized mail to Alaska.
Hawaii orders will be charged a flat $35 charge and will be shipped Post Office Priority Mail. We do not ship Oversized mail to Hawaii.
Puerto Rico orders will be charged a flat $35 charge and will be shipped Post Office Priority Mail. We do not ship Oversized mail to Puerto Rico.
RELATED PRODUCTS
