Throttle By Wire Twist Grip Sensor
Hardwired like OEM CVO version from the sensor to the main connection on the harness. Terminals are pre-installed. Includes 6 position connector for installation after the harness is routed through handlebars. Be sure grip is mated snugly against the gear drive to prevent damage. After installing new twist grip sensor set the right handlebar switch to run. Turn ignition switch on you will hear the fuel pump cycle on and off. Wait 30 seconds and turn ignition switch off. Wait for turn signals to flash for 30 seconds. Repeat this process 2 more times. This will reset the throttle body and make it in sync with new twist grip sensor.
Measurements: Short Wire Length: 26-1/2 inches
Instructions: http://www.vtwinmfg.com/Instructions/36/36-1885.pdf
FITS
Harley Davidson FLT 2008
Harley Davidson FLT 2009
Harley Davidson FLT 2010
Harley Davidson FLT 2011
Harley Davidson FLT 2012
Harley Davidson FLT 2013
Orders over $145.95 qualify for free shipping.
Orders under $145.95pay a flat shipping rate of $10.95 Offer only applies to 48 contiguous states. Hazardous Materials ship UPS Ground only.
Orders that contain backorders, the order will be held until all parts are in. A customer representative will reach out to you if this is the case. At that time a decision can be made whether or not to split the order.
Alaska orders will be charged a flat $35 charge and will be shipped Post Office Priority Mail. We do not ship Oversized mail to Alaska.
Hawaii orders will be charged a flat $35 charge and will be shipped Post Office Priority Mail. We do not ship Oversized mail to Hawaii.
Puerto Rico orders will be charged a flat $35 charge and will be shipped Post Office Priority Mail. We do not ship Oversized mail to Puerto Rico.
